CHAPTER 16
IP Multicast Optimization: IP Multicast Load
Splitting across Equal-Cost Paths
•
Finding Feature Information, page 349
•
Prerequisites for IP Multicast Load Splitting across Equal-Cost Paths, page 349
•
Information About IP Multicast Load Splitting across Equal-Cost Paths, page 350
•
How to Load Split IP Multicast Traffic over ECMP, page 360
•
Configuration Examples for Load Splitting IP Multicast Traffic over ECMP, page 367
•
Additional References, page 368
•
Feature History and Information for Load Splitting IP Multicast Traffic over ECMP, page 369
Finding Feature Information
Your software release may not support all the features documented in this module. For the latest caveats and
feature information, see Bug Search Tool and the release notes for your platform and software release. To
find information about the features documented in this module, and to see a list of the releases in which each
feature is supported, see the feature information table at the end of this module.
Use Cisco Feature Navigator to find information about platform support and Cisco software image support.
To access Cisco Feature Navigator, go to http://www.cisco.com/go/cfn. An account on Cisco.com is not
required.
Prerequisites for IP Multicast Load Splitting across Equal-Cost
Paths
IP multicast is enabled on the device using the tasks described in the “Configuring Basic IP Multicast” module
of the IP Multicast: PIM Configuration Guide.
IP Multicast Routing Configuration Guide, Cisco IOS XE Release 3.6E (Catalyst 3850 Switches)
OL-32598-01 349
To Next Page
Loading...
