PurposeCommand or Action
(Optional) Saves your entries in the configuration file.copy running-config startup-config
Example:
Device# copy running-config
Step 7
startup-config
Configuring the Device as a Statically Connected Member (CLI)
At various times, either there is not a group member on a network segment or a host that cannot report its
group membership by using IGMP. However, you may want multicast traffic to be sent to that network
segment. The following commands are used to pull multicast traffic down to a network segment:
• ip igmp join-group—The device accepts the multicast packets in addition to forwarding them. Accepting
the multicast packets prevents the device from fast switching.
• ip igmp static-group—The device does not accept the packets itself, but only forwards them. This
method enables fast switching. The outgoing interface appears in the IGMP cache, but the device itself
is not a member, as evidenced by lack of an L (local) flag in the multicast route entry.
This procedure is optional.
SUMMARY STEPS
1.
enable
2.
configure terminal
3.
interface interface-id
4.
ip igmp static-group group-address
5.
end
6.
show ip igmp interface [interface-id]
7.
copy running-config startup-config
DETAILED STEPS
PurposeCommand or Action
Enables privileged EXEC mode. Enter your password if prompted.enable
Step 1
Example:
Device> enable
IP Multicast Routing Configuration Guide, Cisco IOS XE Release 3.6E (Catalyst 3850 Switches)
OL-32598-01 57
Configuring IGMP
Configuring the Device as a Statically Connected Member (CLI)
To Next Page
Loading...
