Cisco Catalyst 3850 series

Where to Go Next for Configuring Services Discovery Gateway
You can configure the following:
•
IGMP
•
Wireless Multicast
•
PIM
•
SSM
•
IP Multicast Routing
You can also review the following IP Multicast Optimization processes for your configuration:
•
Optimizing PIM Sparse Mode in a Large IP Multicast Deployment
•
Multicast Subsecond Convergence
•
IP Multicast Load Splitting across Equal-Cost Paths
•
SSM Channel Based Filtering for Multicast
•
PIM Dense Mode State Refresh
•
IGMP State Limit
Additional References
Related Documents
Document TitleRelated Topic
IP Addressing: DNS Configuration Guide, Cisco IOS
XE Release 3SE
Configuring DNS
'Information About DNS' section in IP Addressing:
DNS Configuration Guide, Cisco IOS XE Release
3SE
DNS conceptual information
IP Addressing: DNS Configuration Guide, Cisco IOS
XE Release 3SE
Platform-independent configuration information
IP Multicast Routing Configuration Guide, Cisco IOS XE Release 3.6E (Catalyst 3850 Switches)
OL-32598-01 325
Configuring the Service Discovery Gateway
Where to Go Next for Configuring Services Discovery Gateway