EasyManuals Logo

Cisco Catalyst 3850 series User Manual

Cisco Catalyst 3850 series
424 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #253 background imageLoading...
Page #253 background image
SUMMARY STEPS
1.
enable
2.
configure terminal
3.
ip msdp originator-id type number
4.
exit
DETAILED STEPS
PurposeCommand or Action
Enables privileged EXEC mode.enable
Step 1
Example:
Device> enable
•
Enter your password if prompted.
Enters global configuration mode.configure terminal
Example:
Device# configure terminal
Step 2
Configures the RP address in SA messages to be the address
of the originating device’s interface.
ip msdp originator-id type number
Example:
Device(config)# ip msdp originator-id
ethernet 1
Step 3
Exits global configuration mode and returns to privileged
EXEC mode.
exit
Example:
Device(config)# exit
Step 4
Monitoring MSDP
Perform this optional task to monitor MSDP SA messages, peers, state, and peer status.
IP Multicast Routing Configuration Guide, Cisco IOS XE Release 3.6E (Catalyst 3850 Switches)
OL-32598-01 229
Configuring MSDP
Monitoring MSDP

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Catalyst 3850 series and is the answer not in the manual?

Cisco Catalyst 3850 series Specifications

General IconGeneral
ModelCisco Catalyst 3850 Series
RAM4 GB
Flash Memory4 GB
Stacking Bandwidth480 Gbps
Device TypeSwitch
Enclosure TypeRack-mountable
Routing ProtocolOSPF, EIGRP, BGP, RIP
Remote Management ProtocolSNMP, CLI, HTTP, HTTPS
FeaturesQuality of Service (QoS)
StackingYes
Memory4 GB RAM
Operating SystemCisco IOS
Relative Humidity10 - 95% (non-condensing)
Power Supply OptionsAC or DC
Ports24 or 48 10/100/1000 Ethernet ports

Related product manuals