Example Enabling ECMP Multicast Load Splitting Based on Source and Group
Address
The following example shows how to enable ECMP multicast load splitting on a router based on source and
group address using the basic S-G-hash algorithm:
ip multicast multipath s-g-hash basic
Related Topics
Enabling ECMP Multicast Load Splitting Based on Source and Group Address, on page 364
ECMP Multicast Load Splitting Based on Source and Group Address Using the Basic S-G-Hash Algorithm,
on page 353
Example Enabling ECMP Multicast Load Splitting Based on Source Group and
Next-Hop Address
The following example shows how to enable ECMP multicast load splitting on a router based on source,
group, and next-hop address using the next-hop-based S-G-hash algorithm:
ip multicast multipath s-g-hash next-hop-based
Related Topics
Enabling ECMP Multicast Load Splitting Based on Source Group and Next-Hop Address, on page 365
ECMP Multicast Load Splitting Based on Source Group and Next-Hop Address, on page 355
Additional References
Related Documents
Document TitleRelated Topic
Cisco IOS Master Commands List, All Releases
Cisco IOS commands
Cisco IOS IP Multicast Command Reference
Cisco IOS IP Multicast commands
Standards and RFCs
TitleStandard/RFC
Protocol Independent Multicast-Sparse Mode
(PIM-SM): Protocol Specification
RFC 4601
IP Multicast Routing Configuration Guide, Cisco IOS XE Release 3.6E (Catalyst 3850 Switches)
368 OL-32598-01
IP Multicast Optimization: IP Multicast Load Splitting across Equal-Cost Paths
Example Enabling ECMP Multicast Load Splitting Based on Source and Group Address
To Next Page
Loading...
