Cisco Catalyst 3850 series User Manual

Controlling the Forwarding of SA Messages to MSDP Peers Using Outgoing
Filter Lists
Perform this optional task to control the forwarding of SA messages to MSDP peers by configuring outgoing
filter lists.
For best practice information related to configuring MSDP SA message filters, see the Multicast Source
Discovery Protocol SA Filter Recommendations tech note.
Note
SUMMARY STEPS
1.
enable
2.
configure terminal
3.
ip msdp sa-filter out {peer-address | peer-name} [list access-list] [route-map map-name] [rp-list
access-list | rp-route-map map-name]
4.
Repeat Step 3 to configure outgoing filter lists for additional MSDP peers.
5.
exit
DETAILED STEPS
PurposeCommand or Action
Enables privileged EXEC mode.enable
Step 1
Example:
Device> enable
•
Enter your password if prompted.
Enters global configuration mode.configure terminal
Example:
Device# configure terminal
Step 2
Enables a filter for outgoing MSDP messages.
ip msdp sa-filter out {peer-address | peer-name} [list
access-list] [route-map map-name] [rp-list access-list |
rp-route-map map-name]
Step 3
Example:
Device(config)# ip msdp sa-filter out 192.168.1.5
peerone
--Repeat Step 3 to configure outgoing filter lists for additional
MSDP peers.
Step 4
IP Multicast Routing Configuration Guide, Cisco IOS XE Release 3.6E (Catalyst 3850 Switches)
222 OL-32598-01
Configuring MSDP
Controlling the Forwarding of SA Messages to MSDP Peers Using Outgoing Filter Lists

Cisco Catalyst 3850 series Specifications

General

Model	Cisco Catalyst 3850 Series
RAM	4 GB
Flash Memory	4 GB
Stacking Bandwidth	480 Gbps
Device Type	Switch
Enclosure Type	Rack-mountable
Routing Protocol	OSPF, EIGRP, BGP, RIP
Remote Management Protocol	SNMP, CLI, HTTP, HTTPS
Features	Quality of Service (QoS)
Stacking	Yes
Memory	4 GB RAM
Operating System	Cisco IOS
Relative Humidity	10 - 95% (non-condensing)
Power Supply Options	AC or DC
Ports	24 or 48 10/100/1000 Ethernet ports