Cisco Catalyst 3850 series

DETAILED STEPS
PurposeCommand or Action
Enables privileged EXEC mode.enable
Step 1
Example:
Device> enable
•
Enter your password if prompted.
Enters global command mode.configure terminal
Example:
Device# configure terminal
Step 2
Enables the multicast traffic for wireless clients and enables mDNS
bridging. The default value is disable. Add no in the command to
wireless multicast
Example:
Device(config)# wireless multicast
Step 3
disable the multicast traffic for wireless clients and disable mDNS
bridging.
Enables forwarding mode in multicast. Add no in the command
to disable the multicast mode.
no ap capwap multicast ipaddr
Example:
Device(config)# no ap capwap multicast
231.1.1.1
Step 4
Exits the configuration mode. Alternatively, press Ctrl-Z to exit
the configuration mode.
end
Example:
Device(config)# end
Step 5
Related Topics
Information About Wireless Multicast, on page 242
Configuring IPv6 Snooping (CLI)
SUMMARY STEPS
1.
enable
2.
configure terminal
3.
ipv6 mld snooping
DETAILED STEPS
PurposeCommand or Action
Enables privileged EXEC mode.enable
Step 1
IP Multicast Routing Configuration Guide, Cisco IOS XE Release 3.6E (Catalyst 3850 Switches)
248 OL-32598-01
Configuring Wireless Multicast
Configuring IPv6 Snooping (CLI)