Cisco Catalyst 3850 series User Manual

PurposeCommand or Action
Enters global configuration mode.configure terminal
Example:
Device# configure terminal
Step 2
Specifies the interface and enters interface configuration
mode.
interface type slot / subslot / port
Example:
Device(config)# interface gigabitethernet 1/0/0
Step 3
Configures the frequency at which multicast routers send
PIM router query messages.
ip pim query-interval period [msec]
Example:
Device(config-if)# ip pim query-interval 45
Step 4
Related Topics
PIM Router Query Messages, on page 340
Modifying the PIM Router Query Message Interval Example, on page 347
Verifying Multicast Subsecond Convergence Configurations
Perform this task to display detailed information about and to verify information regarding the Multicast
Subsecond Convergence feature.
SUMMARY STEPS
1.
enable
2.
show ip pim interface type number
3.
show ip pim neighbor
DETAILED STEPS
Step 1
enable
Example:
Device> enable
Enables privileged EXEC mode.
•
Enter your password if prompted.
IP Multicast Routing Configuration Guide, Cisco IOS XE Release 3.6E (Catalyst 3850 Switches)
OL-32598-01 345
IP Multicast Optimization: Multicast Subsecond Convergence
Verifying Multicast Subsecond Convergence Configurations

Cisco Catalyst 3850 series Specifications

General

Model	Cisco Catalyst 3850 Series
RAM	4 GB
Flash Memory	4 GB
Stacking Bandwidth	480 Gbps
Device Type	Switch
Enclosure Type	Rack-mountable
Routing Protocol	OSPF, EIGRP, BGP, RIP
Remote Management Protocol	SNMP, CLI, HTTP, HTTPS
Features	Quality of Service (QoS)
Stacking	Yes
Memory	4 GB RAM
Operating System	Cisco IOS
Relative Humidity	10 - 95% (non-condensing)
Power Supply Options	AC or DC
Ports	24 or 48 10/100/1000 Ethernet ports