Cisco Catalyst 3850 series

CHAPTER 11
Configuring SSM
•
Finding Feature Information, page 259
•
Prerequisites for Configuring SSM, page 259
•
Restrictions for Configuring SSM, page 260
•
Information About SSM and SSM Mapping, page 261
•
How to Configure SSM and SSM Mapping, page 267
•
Monitoring SSM and SSM Mapping, page 279
•
Configuration Examples for SSM and SSM Mapping, page 280
•
Additional References, page 284
•
Feature History and Information for SSM, page 286
Finding Feature Information
Your software release may not support all the features documented in this module. For the latest caveats and
feature information, see Bug Search Tool and the release notes for your platform and software release. To
find information about the features documented in this module, and to see a list of the releases in which each
feature is supported, see the feature information table at the end of this module.
Use Cisco Feature Navigator to find information about platform support and Cisco software image support.
To access Cisco Feature Navigator, go to www.cisco.com/go/cfn. An account on Cisco.com is not required.
Prerequisites for Configuring SSM
The following are the prerequisites for configuring source-specific multicast (SSM) and SSM mapping:
•
Before you configure SSM mapping, you must perform the following tasks:
◦
Enable IP multicast routing.
◦
Enable PIM sparse mode.
◦
Configure SSM.
IP Multicast Routing Configuration Guide, Cisco IOS XE Release 3.6E (Catalyst 3850 Switches)
OL-32598-01 259