Cisco Catalyst 3850 series

PurposeCommand or Action
Clears the TCP connection to the specified MSDP peer and resets
all MSDP message counters.
clear ip msdp peer [peer-address | peer-name]
Example:
Device# clear ip msdp peer
Step 2
Clears the statistics counters for the specified MSDP peer and resets
all MSDP message counters.
clear ip msdp statistics [peer-address |
peer-name]
Example:
Device# clear ip msdp statistics
Step 3
Clears SA cache entries.
clear ip msdp sa-cache [group-address]
Step 4
Example:
Device# clear ip msdp sa-cache
•
If the clear ip msdp sa-cache is specified with the optional
group-address argument or source-addressargument, all SA
cache entries are cleared.
•
Use the optional group-address argument to clear all SA cache
entries associated with a specific group.
Enabling SNMP Monitoring of MSDP
Perform this optional task to enable Simple Network Management Protocol (SNMP) monitoring of MSDP.
Before You Begin
•
SNMP and MSDP is configured on your devices.
•
In each PIM-SM domain there should be a device that is configured as the MSDP speaker. This device
must have SNMP and the MSDP MIB enabled.
Note
•
All MSDP-MIB objects are implemented as read-only.
• The Requests table is not supported in Cisco’s implementation of the MSDP MIB.
• The msdpEstablished notification is not supported in Cisco’s implementation of the MSDP MIB.
IP Multicast Routing Configuration Guide, Cisco IOS XE Release 3.6E (Catalyst 3850 Switches)
OL-32598-01 233
Configuring MSDP
Enabling SNMP Monitoring of MSDP