PurposeCommand or Action
Enters the global configuration mode.configure terminal
Example:
Device# configure terminal
Step 2
Specifies the Layer 3 interface on which you want to enable multicast
routing, and enters interface configuration mode.
interface interface-id
Example:
Device(config)# interface
Step 3
The specified interface must be one of the following:
• A routed port—A physical port that has been configured as a Layer
3 port by entering the no switchport interface configuration command.
gigabitethernet 1/0/1
You will also need to enable IP PIM sparse-dense-mode on the
interface, and join the interface as a statically connected member to
an IGMP static group. For a configuration example, see Example:
Interface Configuration as a Routed Port, on page 95.
• An SVI—A VLAN interface created by using the interface vlan
vlan-id global configuration command. You will also need to enable
IP PIM sparse-dense-mode on the VLAN, join the VLAN as a
statically connected member to an IGMP static group, and then enable
IGMP snooping on the VLAN, the IGMP static group, and physical
interface. For a configuration example, see Example: Interface
Configuration as an SVI, on page 96.
These interfaces must have IP addresses assigned to them.
Configures the device as a statically connected member of a group.
ip igmp static-group group-address
Step 4
Example:
Device(config-if)# ip igmp
By default, this feature is disabled.
static-group 239.100.100.101
Returns to privileged EXEC mode.end
Example:
Device(config)# end
Step 5
Verifies your entries.
show ip igmp interface [interface-id]
Example:
Device# show ip igmp interface
Step 6
gigabitethernet 1/0/1
IP Multicast Routing Configuration Guide, Cisco IOS XE Release 3.6E (Catalyst 3850 Switches)
58 OL-32598-01
Configuring IGMP
Configuring the Device as a Statically Connected Member (CLI)
To Next Page
Loading...
