EasyManuals Logo

Cisco Catalyst 3850 series User Manual

Cisco Catalyst 3850 series
424 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #26 background imageLoading...
Page #26 background image
Table 1: Command Mode Summary
About This ModeExit MethodPromptAccess MethodMode
Use this mode to
•
Change
terminal
settings.
•
Perform basic
tests.
•
Display system
information.
Enter logout or
quit.
Device>
Begin a session
using Telnet, SSH,
or console.
User EXEC
Use this mode to
verify commands
that you have
entered. Use a
password to protect
access to this mode.
Enter disable
to exit.
Device#
While in user
EXEC mode, enter
the enable
command.
Privileged EXEC
Use this mode to
configure parameters
that apply to the
entire device.
To exit to
privileged
EXEC mode,
enter exit or
end, or press
Ctrl-Z.
Device(config)#
While in privileged
EXEC mode, enter
the configure
command.
Global
configuration
Use this mode to
configure VLAN
parameters. When
VTP mode is
transparent, you can
create
extended-range
VLANs (VLAN IDs
greater than 1005)
and save
configurations in the
device startup
configuration file.
To exit to
global
configuration
mode, enter the
exit command.
To return to
privileged
EXEC mode,
press Ctrl-Z or
enter end.
Device(config-vlan)#
While in global
configuration
mode, enter the
vlan vlan-id
command.
VLAN
configuration
Use this mode to
configure parameters
for the Ethernet
ports.
Device(config-if)#
While in global
configuration
mode, enter the
interface command
(with a specific
interface).
Interface
configuration
IP Multicast Routing Configuration Guide, Cisco IOS XE Release 3.6E (Catalyst 3850 Switches)
2 OL-32598-01
Using the Command-Line Interface
Command Modes

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Catalyst 3850 series and is the answer not in the manual?

Cisco Catalyst 3850 series Specifications

General IconGeneral
ModelCisco Catalyst 3850 Series
RAM4 GB
Flash Memory4 GB
Stacking Bandwidth480 Gbps
Device TypeSwitch
Enclosure TypeRack-mountable
Routing ProtocolOSPF, EIGRP, BGP, RIP
Remote Management ProtocolSNMP, CLI, HTTP, HTTPS
FeaturesQuality of Service (QoS)
StackingYes
Memory4 GB RAM
Operating SystemCisco IOS
Relative Humidity10 - 95% (non-condensing)
Power Supply OptionsAC or DC
Ports24 or 48 10/100/1000 Ethernet ports

Related product manuals