Name: Cisco Catalyst 3850 series
Brand: Cisco
Rating: 4 (1 reviews)

To Next Page

To Previous Page

PurposeCommand or Action

VLAN, the IGMP static group, and physical interface. For a configuration

example, see Example: Interface Configuration as an SVI, on page 96

These interfaces must have IP addresses assigned to them.

Enables a PIM mode on the interface.ip pim {dense-mode | sparse-mode |

sparse-dense-mode}

Step 5

By default, no mode is configured.

Example:

Device(config-if)# ip pim

The keywords have these meanings:

• dense-mode—Enables dense mode of operation.

sparse-dense-mode

• sparse-mode—Enables sparse mode of operation. If you configure sparse

mode, you must also configure an RP.

• sparse-dense-mode—Causes the interface to be treated in the mode in

which the group belongs. Sparse-dense mode is the recommended setting.

To disable PIM on an interface, use the no ip pim interface

configuration command.

Note

Returns to privileged EXEC mode.end

Example:

Device(config-if)# end

Step 6

Verifies your entries.show running-config

Example:

Device# show running-config

Step 7

(Optional) Saves your entries in the configuration file.copy running-config startup-config

Example:

Device# copy running-config

Step 8

startup-config

Questions and Answers:

Need help?

Do you have a question about the Cisco Catalyst 3850 series and is the answer not in the manual?

Cisco Catalyst 3850 series Specifications

General