PurposeCommand or Action
Permits specified ip host traffic.
permit protocol host address host address
Example:
Device(config-ext-nacl)# permit ip host 181.1.2.201
host 232.1.1.11
Step 4
Denies specified multicast ip group and source
traffic.
deny protocol host address host address
Example:
Device(config-acl-nacl)# deny ip host 181.1.2.203 host
232.1.1.1
Step 5
Permits and denies specified host and source
traffic.
Repeat Step 4 or Step 5 as needed.
Step 6
Enables interface configuration mode.
interface type interface-number port -number
Example:
Device(config)# interface gigabitethernet 2/3/0
Step 7
Configures the multicast boundary.
The filter-autorp keyword does not
support extended access lists.
Note
ip multicast boundary access-list-name [in| out |
filter-autorp]
Example:
Device(config-if)# ip multicast boundary acc_grp1 out
Step 8
Related Topics
Rules for Multicast Boundaries, on page 372
Configuring the Multicast Boundaries Permitting and Denying Traffic Example, on page 375
Configuring the Multicast Boundaries Permitting Traffic Example, on page 375
Configuring the Multicast Boundaries Denying Traffic Example, on page 375
IP Multicast Routing Configuration Guide, Cisco IOS XE Release 3.6E (Catalyst 3850 Switches)
374 OL-32598-01
IP Multicast Optimization: SSM Channel Based Filtering for Multicast
Configuring Multicast Boundaries
To Next Page
Loading...
