PurposeCommand or Action
Assigns a number to the profile you are configuring, and enters IGMP
profile configuration mode. The profile number range is 1 to 4294967295.
ip igmp profile profile number
Example:
Device(config)# ip igmp profile 3
Step 3
When you are in IGMP profile configuration mode, you can create the
profile by using these commands:
• deny—Specifies that matching addresses are denied; this is the default.
• exit—Exits from igmp-profile configuration mode.
• no—Negates a command or returns to its defaults.
• permit—Specifies that matching addresses are permitted.
• range—Specifies a range of IP addresses for the profile. You can
enter a single IP address or a range with a start and an end address.
The default is for the device to have no IGMP profiles configured.
To delete a profile, use the no ip igmp profile profile number
global configuration command.
Note
(Optional) Sets the action to permit or deny access to the IP multicast
address. If no action is configured, the default for the profile is to deny
access.
permit | deny
Example:
Device(config-igmp-profile)# permit
Step 4
Enters the IP multicast address or range of IP multicast addresses to which
access is being controlled. If entering a range, enter the low IP multicast
address, a space, and the high IP multicast address.
range ip multicast address
Example:
Device(config-igmp-profile)# range
Step 5
You can use the range command multiple times to enter multiple addresses
or ranges of addresses.
229.9.9.0
To delete an IP multicast address or range of IP multicast addresses,
use the no range ip multicast address IGMP profile configuration
command.
Note
Returns to privileged EXEC mode.end
Example:
Device(config)# end
Step 6
Verifies the profile configuration.
show ip igmp profile profile number
Example:
Device# show ip igmp profile 3
Step 7
IP Multicast Routing Configuration Guide, Cisco IOS XE Release 3.6E (Catalyst 3850 Switches)
60 OL-32598-01
Configuring IGMP
Configuring IGMP Profiles (CLI)
To Next Page
Loading...
