Name: Cisco RVS4000 - Gigabit Security Router
Brand: Cisco
Rating: 4 (1 reviews)

To Next Page

To Previous Page

Using the VPN Setup Wizard

Running the VPN Setup Wizard

Cisco RVS4000 Security Router with VPN Administrator Guide 110

Configure VPN Tunnel Window

• Router 1 User Name: Enter the user name of the Router 1.

• Router 1 Password: Enter the password of the Router 1.

• Router 2 User Name: Enter the user name of the Router 2.

• Router 2 Password: Enter the password of the Router 2.

• Tunnel Name: Enter a name for this tunnel.

• Pre-shared Key: IKE uses the Pre-shared Key field to authenticate the

remote IKE peer. Both character and hexadecimal values are acceptable in

this field; e.g.,“My_@123” or “0x4d795f40313233”. Note that both sides must

use the same Pre-shared Key.

• Router 1 WAN IP address: Enter the WAN IP address of the Router 1.

• Router 1 IP by DNS Resolved: Enter the DDNS Domain Name of Router 1 if

it does not have a static IP address for its internet connection.

• Router 2 WAN IP address: Enter the WAN IP address of the Router 2.

• Router 2 IP by DNS Resolved: Enter the DDNS Domain Name of Router 2 if

it does not have a static IP address for its internet connection.

Other manuals for Cisco RVS4000 - Gigabit Security Router

Questions and Answers:

Need help?

Do you have a question about the Cisco RVS4000 - Gigabit Security Router and is the answer not in the manual?

General