Name: Cisco RVS4000 - Gigabit Security Router
Brand: Cisco
Rating: 4 (1 reviews)

To Next Page

To Previous Page

Setting Up and Configuring the Router

Setup

Cisco RVS4000 Security Router with VPN Administrator Guide 42

Setup > Advanced Routing

Operating Mode

Operation Mode Select the Operating mode for this router:

• Gateway The normal mode of operation. This allows all devices on your

LAN to share the same WAN (Internet) IP address. In Gateway mode, the

NAT (Network Address Translation) mechanism is enabled.

• Router You either need another router to act as the Internet Gateway, or all

PCs on your LAN must be assigned (fixed) Internet IP addresses. In Router

mode, the NAT mechanism is disabled.

Dynamic Routing

You can use the router’s dynamic routing feature to automatically adjust to physical

changes in the network’s layout. The router can use the dynamic RIP protocol to

calculate the most efficient route for the network’s data packets to travel between

the source and the destination, based upon the shortest paths. The RIP protocol

regularly broadcasts routing information to other routers on the network.

RIP (Routing Information Protocol) If you want the router to use the RIP protocol,

select Enabled; otherwise, keep the default setting, Disabled.

Other manuals for Cisco RVS4000 - Gigabit Security Router

Questions and Answers:

Need help?

Do you have a question about the Cisco RVS4000 - Gigabit Security Router and is the answer not in the manual?

General