Cisco RVS4000 - Gigabit Security Router Administration Guide

Setting Up and Configuring the Router
Status
Cisco RVS4000 Security Router with VPN Administrator Guide 97
5
Status > Local Network
Status > Local Network
Current IP address System This shows the current system.
MAC Address The router MAC Address, as seen on your local, Ethernet network.
IP Address The Internet IP Address.
Subnet Mask The Subnet Mask for the IP address above.
IPv6 Address The IPv6 IP address, if applicable.
DHCP Server The status of the router’s DHCP server function.
Start IP Address The first address in the range of IP addresses used by the DHCP
Server.
End IP Address The final address in the range of IP addresses used by the DHCP
Server.
DHCP Client Table Click this button to open a window that displays the PCs that
use the router as a DHCP server. The DHCP Client Table window displays all
DHCP clients (PCs and other network devices) with this information: Client Names,
Interfaces, IP Addresses, MAC Addresses, and the length of time before their
assigned IP addresses expire.
ARP/RARP Table Click this button to open a window that displays the PCs that
use the router as an ARP/RARP server. The ARP/RARP Table window displays all
ARPs/RARPs (PCs and other network devices) with this information: IP addresses
and MAC addresses.

Cisco RVS4000 - Gigabit Security Router Specifications

General

WAN Ports	1 x 10/100/1000 Mbps
LAN Ports	4 x 10/100/1000 Mbps
VPN Support	IPSec, PPTP
Wireless	No
QoS	Yes
Power Supply	12V DC, 1.5A
Humidity	10% to 85% non-condensing
Firewall	SPI Firewall
VPN Throughput	30 Mbps
Operating Temperature	32°F to 104°F (0°C to 40°C)
Storage Temperature	-4°F to 158°F (-20°C to 70°C)
Management	Web-based