Name: Cisco RVS4000 - Gigabit Security Router
Brand: Cisco
Rating: 4 (1 reviews)

To Next Page

To Previous Page

Setting Up and Configuring the Router

Firewall

Cisco RVS4000 Security Router with VPN Administrator Guide 46

Firewall

Use the Firewall menu to configure the router to deny or allow specific internal

users from accessing the Internet. You can also configure the router to deny or

allow specific Internet users from accessing the internal servers. You can set up

different packet filters for different users on the internal (LAN) side or external

(WAN) side based on their IP addresses or their network Port number.

Firewall > Basic Settings

Firewall When this feature is enabled, the router’s NAT firewall feature is enabled.

DoS Protection When this feature is enabled, the router blocks DoS (Denial of

Service) attacks. A DoS attack does not attempt to steal data or damage your PCs,

but overloads your Internet connection so you can not use it.

Block WAN Request When this feature is enabled, the router filters out

anonymous requests from the WAN.

Remote Management This feature allows you to use an http or https port to

remotely manage the router. To enable this feature, select Enable and enter the

port number in the Port field, then configure the HTTPS and Remote IP address

settings that appear below.

Other manuals for Cisco RVS4000 - Gigabit Security Router

Questions and Answers:

Need help?

Do you have a question about the Cisco RVS4000 - Gigabit Security Router and is the answer not in the manual?

General