Name: Cisco RVS4000 - Gigabit Security Router
Brand: Cisco
Rating: 4 (1 reviews)

To Next Page

To Previous Page

Getting Started with the RVS4000 Router

Placement Options

Cisco RVS4000 Security Router with VPN Administrator Guide 21

To place the router vertically, follow these steps.

STEP 1 Locate the left side panel of the router.

STEP 2 With the two large prongs of one of the stands facing outward, insert the short

prongs into the little slots in the router and push the stand upward until the stand

snaps into place.

STEP 3 Repeat step 2 with the other stand.

Wall Option

To mount the Cisco RVS4000 router on the wall, follow these steps.

STEP 1 Determine where you want to mount the router and install two screws (not

supplied) that are 2-9/16 in. apart (approximately 64.5 mm).

STEP 2 With the back panel pointing up (if installing vertically), line up the router so that the

wall-mount crisscross slots on the bottom of the access point line up with the two

screws.

STEP 3 Place the wall-mount slots over the screws and slide the router down until the

screws fit snugly into the wall-mount slots.

193817

Wall

mount

slots

2-9/16

Other manuals for Cisco RVS4000 - Gigabit Security Router

Questions and Answers:

Need help?

Do you have a question about the Cisco RVS4000 - Gigabit Security Router and is the answer not in the manual?

General