Name: Cisco RVS4000 - Gigabit Security Router
Brand: Cisco
Rating: 4 (1 reviews)

To Next Page

To Previous Page

Getting Started with the RVS4000 Router

Installing the Router

Cisco RVS4000 Security Router with VPN Administrator Guide 22

Installing the Router

To prepare the router for installation complete these tasks:

• Obtain the setup information for your specific type of Internet connection

from your Internet Service Provider (ISP).

• Power off all of your network hardware, including the router, PCs, and cable

modem or DSL modem.

Perform the steps in this section to install the hardware.

STEP 1 Connect one end of an Ethernet network cable to one of the LAN ports

(labeled 1-4) on the back of the router. Connect the other end to an Ethernet port

on a PC.

STEP 2 Repeat step 1 to connect up to four PCs, switches, or other network devices to the

router.

STEP 3 Connect an Ethernet network cable from your cable modem or DSL modem to the

Internet port on the back panel of the router.

Other manuals for Cisco RVS4000 - Gigabit Security Router

Questions and Answers:

Need help?

Do you have a question about the Cisco RVS4000 - Gigabit Security Router and is the answer not in the manual?

General