Name: Cisco RVS4000 - Gigabit Security Router
Brand: Cisco
Rating: 4 (1 reviews)

To Next Page

To Previous Page

Setting Up and Configuring the Router

L2 Switch

Cisco RVS4000 Security Router with VPN Administrator Guide 90

L2 Switch > RADIUS

Mode Select Enabled or Disabled from the drop-down menu to enable or disable

RADIUS.

RADIUS IP Enter the Server IP address.

RADIUS UDP Port Enter the UDP port. The UDP port is used to verify the RADIUS

server authentication.

RADIUS Secret Enter the Key string for authenticating and encrypting all RADIUS

communications between the device and the RADIUS server. This key must match

the RADIUS server encryption key. If no host-specific value is specified, the global

value applies to each host.

Administration State Specifies the port authorization state. The possible field

values are:

• Auto The controlled port state is set by the Authentication method.

• Force Authorized The controlled port state is set to Force-Authorized

(forward traffic).

• Force Unauthorized The controlled port state is set to Force-Unauthorized

(discard traffic).

Port State Displays the state of the selected port.

Other manuals for Cisco RVS4000 - Gigabit Security Router

Questions and Answers:

Need help?

Do you have a question about the Cisco RVS4000 - Gigabit Security Router and is the answer not in the manual?

General