Cisco RVS4000 - Gigabit Security Router Administration Guide

Setting Up and Configuring the Router
Setup
Cisco RVS4000 Security Router with VPN Administrator Guide 44
5
Click Save to save your changes, or click Cancel to undo your changes.
Setup > Time
Setup > Time
Set the local time Manually If you wish to enter the time and date manually, select
this option, then select the Date from the drop-down fields and enter the hour,
minutes, and seconds in the Time fields in 24-hour format. For example, for 10:00
pm, enter 22 in the hours field, 0 in the minutes field, and 0 in the seconds field.
Set the local time using Network Time Protocol (NTP) Automatically If you wish
to use a Network Time Protocol server to set the time and date, select this option,
and then complete these fields:
Time Zone Select the time zone for your location and your time setting is
synchronized over the Internet.
Auto Daylight Saving If your location observes daylight savings time, select the
Enable option.
User-defined NTP Server To specify a user-defined NTP server, select the Enable
option, then enter the NTP Server’s IP address in the NTP Server IP field.
NTP Server IP If the User-defined NTP Server option is set to Enable, enter the IP
address of the NTP server.
Click Save to save your changes, or click Cancel to undo your changes.

Cisco RVS4000 - Gigabit Security Router Specifications

General

WAN Ports	1 x 10/100/1000 Mbps
LAN Ports	4 x 10/100/1000 Mbps
VPN Support	IPSec, PPTP
Wireless	No
QoS	Yes
Power Supply	12V DC, 1.5A
Humidity	10% to 85% non-condensing
Firewall	SPI Firewall
VPN Throughput	30 Mbps
Operating Temperature	32°F to 104°F (0°C to 40°C)
Storage Temperature	-4°F to 158°F (-20°C to 70°C)
Management	Web-based