Cisco RVS4000 - Gigabit Security Router Administration Guide

Setting Up and Configuring the Router
Administration
Cisco RVS4000 Security Router with VPN Administrator Guide 77
5
Ping Test Parameters
Ping Target IP Enter the IP address or URL that you want to ping.
Ping Size Enter the size of the packet you want to use.
Number of Pings Enter the number of times you wish to ping the target device.
Ping Interval Enter the time period (milliseconds) between each ping.
Ping Timeout Enter the desired time period (milliseconds). If a response is not
received within the defined ping period, the ping is considered to have failed.
Start Test Click this button to begin the test. A new window appears with the test
results.
Ping Result Displays the Ping status.
Traceroute Test Parameters
Traceroute Target Enter the target IP address for the traceroute test.
Start Test Click this button to begin the test. A new window appears with the test
results.
Cable Diagnostics
Port Select the port number from the drop-down menu.
Pair Identifies a specific pair (A, B, C, or D) in the cable. Each cable consists of 8
pins (4 pairs).
Cable Length Displays the length of the cable in meters.
Status Displays the status of the pair.

Cisco RVS4000 - Gigabit Security Router Specifications

General

WAN Ports	1 x 10/100/1000 Mbps
LAN Ports	4 x 10/100/1000 Mbps
VPN Support	IPSec, PPTP
Wireless	No
QoS	Yes
Power Supply	12V DC, 1.5A
Humidity	10% to 85% non-condensing
Firewall	SPI Firewall
VPN Throughput	30 Mbps
Operating Temperature	32°F to 104°F (0°C to 40°C)
Storage Temperature	-4°F to 158°F (-20°C to 70°C)
Management	Web-based