Cisco SCE8000 GBE - Page 169

A-3
Cisco SCE8000 GBE Installation and Configuration Guide
OL-19897-02
Appendix A CLI Commands to Verify a Successful Installation
Basic Post-Installation Checklist
CLI Command Output Samples
The text in bold in the following output samples indicates the lines you should check when doing a
post-installation check. For some commands, the output is short and the entire output is relevant. In these
cases, nothing is in bold.
show version
Look for the following lines:
• System version
• Application file
• Management agent interface version
SCE>show version
System version: Version 3.5.5 Build 252
Build time: May 31 2009, 15:50:44 (Change-list 483168)
Software version is: Version 3.5.5 Build 252
Cryptography class: K9
Hardware information is:
---------------------
Firmware
---------------------
kernel : [kernel] 2.3.0/1 (inactive: [kernel] 2.3.0/1)
u-boot : [uboot] 2.1.0/1 (field: [uboot] 0.8.1/13)
select : [ubs-cf0] 2.3.0/1 (secondary: [ubs-cf0] 2.3.0/1)
---------------------
Slot 1: SCE8000-SCM-E
---------------------
serial-num : CAT1151G012
part-num : 73-10598-01 36
cpld : 0x816c
vtpld : 0xc004
summit-0 : 0xf2c1001
summit-1 : 0xf2c1101
dpt/tx : 0x4913
cls/ff : 0x2112
cls cam : 0x454120
cls flow cap: 33554432
ssa : 0x90
---------------------
TVR
---------------------
#cpus : 1
cpu SVR : 0x80900121
cpu PVR : 0x80040202
cpu freq : 1000MHz
cpu (eeprom): 2.1, 1000MHz
cpld : 0xa1bc
cpld-ufm : 0xa803
summit : 0xf2c1701
cf : Model=SMART CF, S/N=20080213025D41EC41EC, FwRev=0x20060811, Size=4062240KB
phy-0 : 0xcc2
phy-1 : 0xcc2
phy-2 : 0xcc2