Cisco SCE8000 GBE - Page 168

A-2
Cisco SCE8000 GBE Installation and Configuration Guide
OL-19897-02
Appendix A CLI Commands to Verify a Successful Installation
Basic Post-Installation Checklist
Complete command sequence for a fully-populated SCE8000 GBE platform using both the SM and the QM
SCE>enable 5
Password:<cisco>
SCE>show version
SCE>
show inventory
SCE>show interface GigabitEthernet 3/0/0
SCE>show interface GigabitEthernet 3/0/1
SCE>show interface GigabitEthernet 3/0/2
SCE>show interface GigabitEthernet 3/03
SCE>show interface GigabitEthernet 3/0/4
SCE>show interface GigabitEthernet 3/0/5
SCE>show interface GigabitEthernet 3/0/6
SCE>show interface GigabitEthernet 3/0/7
SCE>show interface GigabitEthernet 3/1/0
SCE>show interface GigabitEthernet 3/1/1
SCE>show interface GigabitEthernet 3/1/2
SCE>show interface GigabitEthernet 3/1/3
SCE>show interface GigabitEthernet 3/1/4
SCE>show interface GigabitEthernet 3/1/5
SCE>show interface GigabitEthernet 3/1/6
SCE>show interface GigabitEthernet 3/1/7
SCE>show system operation-status
SCE>show interface linecard 0
SCE>show interface linecard 0 connection-mode
SCE>show interface linecard 0 link mode
SCE>show interface linecard 0 external-bypass
SCE>show rdr-formatter
SCE>show interface linecard 0 subscriber sm-connection-failure
SCE>show ip rpc-adapter sessions
connection mode show interface linecard
connection-mode
Make sure that both the connection mode and the failure mode
are configured correctly.
link mode show interface linecard link mode When connection-mode is inline, link mode should be
configured to forwarding.
external bypass
configuration
show interface linecard
external-bypass
Only if external bypass modules are installed: Check the
following:
• Configuration should be activated on failure
• The number of devices should match the number of links
RDR formatter show RDR-formatter Verify the following:
• The RDR formatter has established a connection with the
configured destinations
• The redundancy status is configured correctly in case of
more then one destination.
connection to
Subscriber Manager
show interface linecard subscriber
sm-connection-failure
If using SM: Verify that the connection with the SM is
established.
connection to Quota
Manager
show ip rpc-adapter sessions If using QM: Verify that the connection with the QM is
established.
To check this: Use this command: Comments