Smartport
Built-in Smartport Macros
Cisco Small Business 200 Series Smart Switch Administration Guide 159
12
• Interface—Select the port or LAG.
• Smartport Type—Displays the Smartport type currently assigned to the port/LAG.
• Smartport Application—Select the Smartport type from the Smartport Application pull-down.
• Smartport Application Method— If Auto Smartport is selected, Auto Smartport automatically
assigns the Smartport type based on the CDP and/or LLDP advertisement received from the
connecting devices as well as applying the corresponding Smartport macro. To statically assign a
Smartport type and apply the corresponding Smartport macro to the interface, select the desired
Smartport type.
• Persistent Status—Select to enable the Persistent status. If enabled, the association of a Smartport
type to an interface remains even if the interface goes down, or the device is rebooted. Persistent is
applicable only if the Smartport Application of the interface is Auto Smartport. Enabling Persistent at
an interface eliminates the device detection delay that otherwise occurs.
• Macro Parameters—Displays the following fields for up to three parameters in the macro:
- Parameter Name—Name of parameter in macro.
- Parameter Value—Current value of parameter in macro. This can be changed here.
- Parameter Description—Description of parameter.
STEP 3 Click Reset to set an interface to Default if it is in Unknown status (as a result of an
unsuccessful macro application). The macro can be reapplied on the main page.
STEP 4 Click Apply to update the changes and assign the Smartport type to the interface.
Built-in Smartport Macros
The following describes the pair of built-in macros for each Smartport type. For each Smartport type there
is a macro to configure the interface and an anti macro to remove the configuration.
Macro code for the following Smartport types are provided:
• desktop
• printer
• guest
• server
• host
To Next Page
Loading...
Need help?
General