EasyManuals Logo

Cisco Small Business 200 Series Administration Guide

Cisco Small Business 200 Series
337 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #33 background imageLoading...
Page #33 background image
Administration: System Log
Setting Remote Logging Settings
Cisco Small Business 200 Series Smart Switch Administration Guide 32
4
• Flash Memory Logging—Select the severity levels of the messages to be logged to the Flash
memory.
STEP 3 Click Apply. The Running Configuration file is updated.
Setting Remote Logging Settings
The Remote Log Servers page enables defining remote SYSLOG servers to which log messages are sent.
For each server, you can configure the severity of the messages that it receives.
To d e f i n e S Y S LO G s e r v e r s :
STEP 1 Click Administration > System Log > Remote Log Servers.
STEP 2 Enter the following fields:
• IPv4 Source Interface—Select the source interface whose IPv4 address will be used as the source
IPv4 address of SYSLOG messages sent to SYSLOG servers.
• IPv6 Source Interface—Select the source interface whose IPv6 address will be used as the source
IPv6 address of SYSLOG messages sent to SYSLOG servers.
NOTE If the Auto option is selected, the system takes the source IP address from the IP address
defined on the outgoing interface.
Information is described for each previously-configured log server. The fields are described below in the
Add page.
STEP 3 Click Add.
STEP 4 Enter the parameters.
• Server Definition—Select whether to identify the remote log server by IP address or name.
• IP Version—Select the supported IP format.
• IPv6 Address Type—Select the IPv6 address type (if IPv6 is used). The options are:
- Link Local—The IPv6 address uniquely identifies hosts on a single network link. A link local
address has a prefix of FE80, is not routable, and can be used for communication only on the local
network. Only one link local address is supported. If a link local address exists on the interface, this
entry replaces the address in the configuration.

Table of Contents

Other manuals for Cisco Small Business 200 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Small Business 200 Series and is the answer not in the manual?

Cisco Small Business 200 Series Specifications

General IconGeneral
BrandCisco
ModelSmall Business 200 Series
CategorySwitch
LanguageEnglish

Related product manuals