Clear-Com LQ-2W2 - Page 152

User Guide| LQ Series 4.0
19.3.2 Can I connect Clear-Com intercom panels to LQ 4-wire devices?
Yes, Version 2 firmware and later supports Clear-Com Eclipse ECS/EHX matrix to
panel connections.
Matrix+3 connections are not supported.
Drake 4000 panels are supported (baud rate 9600)
19.3.3 How do I set up LQ to work with RTS equipment?
To use RTS equipment you must set the Mode setting to RTS in the CCM:
1. Navigate to Device>Ports>Interface Settings>Mode for the required
device.
2. Select RTS.
Page 153