User Guide| LQ Series 4.0
5. Click Apply changes.
LQ #1 and LQ #2 will now be linked (operation may take up to 30 seconds to
complete). If there is existing configuration on the member LQ, this will be
replaced by the configuration of the master.
6. Navigate to the Overview page (top navigation bar). Both LQ devices should be
displayed on this page.
7. Before continuing, if either LQ device is a LQ-2W2 model, you may need to
auto-null both ports (power must be present on the 2W circuit before auto-null
is possible). For each device to be auto-nulled, navigate to Device > Ports.
Page 50
To Next Page
Loading...
