cobas h 232 User Manual

Putting the Meter into Operation
38
Installing the battery pack
1 Loosen the screws on the battery com-
partment cover until they are protruding
about 4-5 mm (2/10 in).
Always disconnect the external power supply
before inserting the battery connector plug.
2 Hold the battery pack in your hand, with
the wires and the plug pinched between
your thumb and index finger.
3 Plug the connector plug into the socket
and make sure it is fully inserted.
4 Place the battery pack inside the battery
compartment as shown.
To position the battery pack correctly, always
align the ridges on the side of the battery pack
with the ridges on the inside of the battery
compartment.
Preferably use the battery pack that was
shipped with the meter. When the battery
pack is installed, the meter checks if battery
pack and meter are compatible.

cobas h 232 Specifications

General

Device Type	Point-of-care analyzer
Sample Type	Whole blood, plasma
Measured Parameters	Troponin T, Myoglobin, D-Dimer, NT-proBNP
Connectivity	USB
Intended Use	cardiac markers
Data Management	LIS connectivity
Throughput	Single test
Sample Volume	150 µL
Operating Temperature	15-30 °C
Operating Humidity	10-85% (non-condensing)
Display	Color touchscreen
Measurement Principle	Electrochemiluminescence immunoassay (ECLIA)