AlphaBIOS Console 3-27
To format a FAT partition
1.
Start AlphaBIOS and select Hard Disk Setup. Press Enter.
2.
Select the partition to be formatted (see
➊ in Figure 3–18).
3.
Press F6. A dialog box is displayed, asking whether to perform a quick or
standard format (see
➋). If you select Quick Format, the formatting is
completed immediately, but no bad sectors are mapped. If you select
Standard Format, a dialog box similar to that in Figure 3–19 is displayed
while the drive is formatted, showing the progress of the formatting.
Standard formatting maps bad sectors.
4.
Select a format method and press Enter.
Figure 3–19 Standard Formatting
Hard Disk Setup
Disk
0
QLISP1040 #0, SCSI ID 3
510 MB
Partition 1 200 MB NTFS
Partition 2 200 MB Unrecognized
Unused 100 MB
Disk
1
NCRC810 #0, SCSI ID 5 1001 MB
Partition 1 995 MB NTFS
Partition 2 6 MB
FAT
Formatting…
25%
ESC =Cancel
To Next Page
Loading...
