2-8 DS10 Console Reference
2.3
Show Commands
Several commands are used to display the system configuration:
show config, show cpu, show device, show memory, show
network, show pal, show power, and show version.
2.3.1 Show Config
The show config command displays a list of devices found on the
system interconnect and I/O buses. This is the configuration at
the most recent initialization.
Syntax: show config
Example 2–1 Show Config Command
>>> show config
AlphaServer DS10 466 MHz
SRM Console: V5X-XXX
PALcode: OpenVMS PALcode V1.56-45, Tru64 UNIX PALcode V1.50-48
Processors
CPU 0 Alpha 21264-4 466 MHz SROM Revision: V1.8.208
Bcache size: 2 MB
Core Logic
Cchip DECchip 21272-CA Rev 2
Dchip DECchip 21272-DA Rev 2
Pchip 0 DECchip 21272-EA Rev 2
TIG Rev 2.1
Arbiter Rev 3.30 (0x7E)
MEMORY
Array # Size Base Addr
------- ---------- ---------
0 256 MB 000000000
Total Bad Pages = 0
Total Good Memory = 256 MBytes
PCI Hose 00
Bus 00 Slot 01: Acer Labs M1543C USB
Bus 00 Slot 03: Acer Labs M1543C PMU
Bus 00 Slot 07: Acer Labs M1543C
Bridge to Bus 1, ISA
Bus 00 Slot 09: DE500-BA Network Controller
ewa0.0.0.9.0 08-00-2B-86-1B-BA
To Next Page
Loading...
