Compaq ALPHASERVER DS10 - Set Logout; Set Password

Remote Management Console 4-35
4.14.20 set logout
The set logout command sets the amount of time before the RMC
terminates an inactive modem connection. The default is 20
minutes.
The settings are in tens of minutes, 0–9. The zero (0) setting disables logout.
With logout disabled, the RMC never disconnects the idle modem session.
The following example sets the logout timer to 50 minutes.
Syntax: set logout
Example:
61'"WIXPSKSYX
0SKSYX8MQIXIRWSJQMRYXIW
4.14.21 set password
The set password command allows you to set or change the
password that is prompted for at the beginning of a modem
session.
A password must be set to enable access through a modem. The string cannot
exceed 14 characters. For security, the password is not echoed on the screen.
When prompted for verification, type the password again. If you mistype,
reenter the set password command.
Syntax: set password
Example:
61'"WIXTEWW
61'4EWW[SVH
:IVMJMGEXMSR
)6636:IVMJMGEXMSRJEMPIHTEWW[SVHMWRSXWIX
61'"WIXTEWW
61'4EWW[SVH
:IVMJMGEXMSR