4-18 DS10 Console Reference
4.12
Resetting the RMC to Factory Defaults
If the RMC escape sequence is set to something other than the
default, and the sequence has been lost or forgotten, the RMC
must be reset to factory settings to restore the default escape
sequence. See Appendix A.
Figure 4–7 RMC Jumpers (Default Positions)
RMC PIC
Processor
PK0246c
RMC
Jumper
1
WARNING: To prevent injury, access is limited to persons who have
appropriate technical training and experience. Such persons are expected
to understand the hazards of working within this equipment and take
measures to minimize danger to themselves or others.
To Next Page
Loading...
