3-42 DS10 Console Reference
3.10
Switching from AlphaBIOS to SRM Console
You can run firmware-based diagnostics from the SRM console.
You must be in the SRM to boot OpenVMS or UNIX. To switch
from AlphaBIOS to the SRM console, press the Halt/Reset button
on the control panel, and the system will power up. Press the
Halt/Reset button as the system is going through self-tests and
you will be at the SRM console.
Alternatively, select Tru64 UNIX (SRM) or OpenVMS (SRM) from
the Advanced CMOS Setup screen and reset the system.
Figure 3–26 Switching to the SRM Console
PCI Parity Checking: Disabled
Power-up Memory Test: Enabled
AlphaBIOS Password Option: Disabled
Console Selection:
Power-up Memory Test Length: Full
Advanced CMOS Setup F1=Help
Digital UNIX Console (SRM)
Press or to select the firmware console that will be presented
the next time the system is power-cycled.
ESC=Discard Changes F10=Save Changes
PK-0750B-96
Digital UNIX Console (SRM)
Windows NT Console (AlphaBIOS)
OpenVMS Console (SRM)
To Next Page
Loading...
Need help?
General
