AlphaBIOS Console 3-43
Firmware-based diagnostics are run from the SRM console. To boot Tru64
UNIX or OpenVMS, you need to change the Halt/Reset jumper on the
motherboard (see Appendix A).
Follow this procedure to switch from AlphaBIOS to SRM:
1.
In AlphaBIOS, select CMOS Setup and press Enter.
2.
In the CMOS Setup screen press F6. The Advanced CMOS Setup screen
is displayed.
3.
Select Tru64 UNIX console (SRM) or OpenVMS console (SRM) and
press F10.
4.
The CMOS Setup screen is displayed. Press F10 to save the change.
5.
Reset the system by powering off and then on again for the changes to take
effect.
To return to the AlphaBIOS console, issue the alphabios or nt command at the
SRM console prompt.
To Next Page
Loading...
Need help?
General
