Compaq ALPHASERVER DS10 - Status Monitoring; Status Command Fields

Remote Management Console 4-7
4.6 Status Monitoring
Use the RMC status command to check the current state of the
system’s sensors as well as the current escape sequence and
alarm information.
40%8*36178%8 97
*MVQ[EVI6IZM WMSR :
7IVZIV4S[IV 32
61',EPX(IE WWIVXI H
61'4S[IV'SR XVSP 32
4S[IV7YTTP] 3/
7]WXIQ*ERW 3/ '49 *ER3/
8IQTIVEXYVI ®' [EVR MRKWEX ®' TS[IVS JJEX®'
)WGETI7IUYIR GIB? B?61'
6IQSXI%GGIWW (MWE FPIH
61'4EWW[SVH WIX
%PIVX)REFPI (MWEF PIH
%PIVX4IRHMRK =)7
-RMX7XVMRK %8*) :7! 
(MEP7XVMRK %8<(8  
%PIVX7XVMRK      
'SQCQSHI72 334
0EWX%PIVX% '0SWW
;EXGLHSK8MQI V WIGSRH W
%YXSVIFSSX3 **
0SKSYX8MQIV QM RYXIW
9WIV7XVMRK
Table 4–2 Status Command Fields
Field Meaning
Firmware Revision
Revision of RMC firmware on the microcontroller.
Server Power
On = System is on.
Off = System is off.
RMC Halt
Asserted = System has been halted.
Deasserted = Halt has been released from halt.
Continued on next page.