4-8 DS10 Console Reference
Table 4–2 Status Command Fields (Continued)
Power
Control
On = System has powered on from RMC.
Off = System has powered off from RMC.
Power Supply
OK = Auxiliary 5V is working.
System Fans
OK = PCI and system fan are operating.
FAIL = PCI or system fan failure has been detected.
CPU Fan
OK = Fan on CPU chip is operating.
FAIL = CPU fan failure has been detected.
Temperature
Reports current temperature and system limits.
Escape Sequence
Current escape sequence for access to RMC console.
Remote Access
Enable = Modem for remote access is enabled.
Disable = Modem for remote access is disabled.
RMC Password
Set = Password set for modem access.
Not set = No password set for modem access.
Alert Enable
Enabled = Dial-out enabled for sending alerts.
Disabled = Dial-out is disabled for sending alerts.
Alert Pending
Yes = Alert has been triggered.
No = No alert has been triggered.
Init String
Initialization string that was set for modem access.
Dial String
Phone number dialed when an alert occurs.
Alert String
Identifies the system that triggered the alert to the paging
service. Usually the phone number of the monitored system.
Com1_mode
Can be set to snoop, soft-bypass, or firm-bypass.
See Section 4.3.
Last Alert
Type of alert (for example, power supply failed).
Watchdog timer
Reports time set by user using set wdt command; can be up
to 60 seconds in increments of 10. When it times out, alert is
sent.
Autoreboot
ON = Autoreboot feature enabled.
OFF = Autoreboot feature disabled.
Logout Timer
The amount of time before the RMC terminates an inactive
modem connection. The default is 20 minutes.
User String
Notes supplied by user.
To Next Page
Loading...
Need help?
General
