Compaq ALPHASERVER DS10 - Installing Windows NT

DS10 Console Reference
1-22
1.8 Installing Windows NT
Windows NT is installed from the CD-ROM. Insert the CD-ROM
into the drive, start AlphaBIOS Setup, select the menu item
Install Windows NT, and follow the prompts.
Figure 1–5 Installing Windows NT
%P
T
LE&-37

7IXY
T
*!

,IP
T
(MW
T
PE
]
7
]
WXIQ
%P
T
LE&-37

9
TK
VEHI|
,EVH

(MWO

7IXY
T
|
'137

7IXY
T
|
2IX[SVO

7IXY
T
|
-RWXEPP

;MRHS[W

28
9XMPMXMIW

8
%FSYX

%P
T
LE&-37|
4VIWW)28)6XSMRWXEPP;MRHS[W28
)7' !

)\MX
The Halt/Reset jumper on the motherboard must be set to the Windows NT
position for the Halt button to operate (see Section 1.12). If the Halt/Reset
jumper is set in the OpenVMS/Tru64 UNIX position, the Halt button will be
ignored by the Windows NT operating system and have no effect. Properly set,
the Halt button will initiate a system reset.