Compaq ALPHASERVER DS10 - Alphabios Option Key Mapping; Running Utilities from a Serial Terminal

3-46 DS10 Console Reference
3.11.2 Running Utilities from a Serial Terminal
Utilities are run from a serial terminal in the same way as from a monitor with
graphics capabilities enabled. The menus are the same, but some keys are
different.
Table 3-1 AlphaBIOS Option Key Mapping
AlphaBIOS Key VTxxx Key
F1 Ctrl/
A
F2 Ctrl/B
F3 Ctrl/C
F4 Ctrl/D
F5 Ctrl/E
F6 Ctrl/F
F7 Ctrl/P
F8 Ctrl/R
F9 Ctrl/T
F10 Ctrl/U
Insert Ctrl/
V
Delete Ctrl/W
Backs
p
ace Ctrl/H
Esca
p
e Ctrl/[
1. Start AlphaBIOS Setup by issuing the command alphabios.
2. Press F2 in the AlphaBIOS Boot screen.
3. From AlphaBIOS Setup, select Utilities, and select Run Maintenance
Program from the submenu that is displayed. Press Enter.
4. In the Run Maintenance Program dialog box, type the name of the
program to be run in the Program Name field. Then tab to the Location list
box, and select the hard disk partition, floppy disk, or CD-ROM drive from
which to run the program.
5. Press Enter to execute the program.