Remote Management Console 4-1
Chapter 4
Remote Management Console
The remote management console (RMC) provides a command-line user interface
for entering commands to monitor and control the system. In addition to doing
routine monitoring, you can invoke the command-line interface to perform
remote power on/off, halt, and reset.
The RMC can detect alert conditions such as overtemperature, fan failure, and
power supply failure and automatically dial a pager phone number or another
computer system to notify the remote operator of the alert condition.
This chapter explains the operation and use of the RMC. Sections are:
•
RMC Components
•
Terminal Setup
•
Operating Modes
•
Entering the RMC
•
SRM Environment
Variables for COM1
•
Status Monitoring
•
Remote Power (On/Off)
•
Remote Halt (In/Out)
•
Configuring Remote Dial-In
•
Configuring Dial-Out Alert
•
Dialing In
•
Resetting RMC to Factory
Defaults
•
Troubleshooting Tips
•
RMC Commands
To Next Page
Loading...
