Remote Management Console 4-11
Figure 4–6 Halt/Reset Button
PK1043c
Table 4–3 Halt/Reset Button Function under Operating Systems
Operating System Function
OpenVMS and
Tru64 UNIX
Suspends the operating system and
returns control to the SRM or RMC console.
Windows NT
Resets the system.
The Halt button, however, does not override the halt {in, out} commands. If
you halt the system with halt in, you must use halt out to deassert the halt
state.
When you issue either the halt in or halt out command under OpenVMS or
Tru64 UNIX, the terminal exits the RMC and reconnects to the system’s COM1
port.
61'"LEPXMR
6IXYVRMRKXS'31TSVX
61'"LEPXSYX
6IXYVRMRKXS'31TSVX