Remote Management Console 4-17
4.11
Dialing In
To start a remote monitoring session, dial in, using the dial
string you entered during the setup procedure. Enter the RMC
modem password, and then type the escape sequence.
1.
After completing the setup procedure, dial in, enter the RMC password at
the Modem password: prompt. When a prompt is displayed, type the escape
sequence. In the following example, the system is at the SRM console when
the modem connection is made.
%8(8
6-2+-2+
6-2+-2+
'322)'8%65:0%41
1SHIQTEWW[SVH
;IPGSQIXS61':
"""B?B?VQG
(sequence is not echoed)
61'"
2.
At the RMC> prompt, enter commands to monitor and control the remote
system.
3.
When you have finished your modem session, enter the hangup command
to cleanly terminate the modem session and disconnect from the system.
To Next Page
Loading...
Need help?
General
