Remote Management Console 4-23
4.14.1 clear alert
The clear alert command clears the current alert condition and
causes the RMC to stop paging the system operator at the
remote location.
If the alert is not cleared, the RMC continues to page the remote operator every
30 minutes if both remote access and alerts are enabled.
The clear alert command clears the current alert so that the RMC can capture
a new alert. The last alert is stored until a new event overwrites it. The Alert
Pending field of the status command becomes NO after the alert is cleared.
Syntax: clear alert
4.14.2 clear port
The clear port command uses the console port modem control
signals to clear any “stuck” conditions on the system’s COM1
port.
The clear port command attempts to free the port by resetting all UARTs
controlled by the RMC if the port is currently locked by an application program,
without resetting the entire system.
Syntax: clear port
NOTE: This command also causes the modem to disconnect.
4.14.3 disable alert
The disable alert command disables the RMC from paging a
remote system operator.
Monitoring continues and alerts are still logged in the Last Alert field of the
status command, but alerts are not sent to the remote operator.
Syntax: disable alert
To Next Page
Loading...
Need help?
General
