4-22 DS10 Console Reference
Command Conventions
Observe the following conventions for entering RMC commands:
•
Enter enough characters to distinguish the command.
NOTE: The reset and quit commands are exceptions.
You must enter the entire word for these commands to work.
•
For commands consisting of two words, enter the entire first word and at
least one letter of the second word. For example, you can enter disable a
for disable alert.
•
For commands that have parameters, you are prompted for the parameter.
•
Use the Backspace key to erase input.
•
If you enter a nonexistent command or a command that does not follow
conventions, the following message is displayed:
)6636YRORS[RGSQQERH
•
If you enter a string that exceeds 14 characters, the following message is
displayed:
)6636SZIVJPS[
To Next Page
Loading...
Need help?
General
