Setting Jumpers A-7
•
The Halt/Reset Select jumper affects the operation of the control panel Halt
button. You may be changing this jumper if you are switching to or from
the Windows NT operating system.
•
The RMC jumper enables or disables the remote management console.
•
Do not change the setting of the Timer jumper or any of the switches.
Table A-1 Jumpers and Factory Default Positions
Default position Jumper
Halt/Reset
Select
OpenVMS, Tru64 UNIX:
Set for Halt
Windows NT: Set for Reset.
Pins 1-2
Pins 2-3
RMC
Set for Enable RMC Pins 2-3
Timer
Set for Enable Timer Hang jumper loose from pin
1; do not jumper to pin 2.
To change the jumper on the Halt/Reset Select or RMC jumpers, wearing an
anti-static strap, move the pin to the position described in Table A-1.
To Next Page
Loading...
