Operations 1-5
➊
Memory size is determined.
➋
The PCI bridges and attendant buses (indicated as IODn by the console)
are probed and the devices are reported. I/O adapters are configured.
➌ Power-up slot 14 corresponds to the bottom physical slot, slot 0. See Figure
1–3.
Slot Location Physical Slot Number Logical Slot Number
Top 3 17
Second from top 2 16
Second from bottom 1 15
Bottom 0 14
➍ These devices are behind bridge of the card in logical slot 15, physical slot
1, second from the bottom.
➎
This device in is logical slot 16, physical slot 3.
➏
Logical slot 17 is physical slot 4, the top slot.
➐
The SRM console banner and prompt (>>>) are printed.
The SRM console is a command-line interface you use to set or read system
parameters.
If the auto_action environment variable is set to boot or restart and the
os_type environment variable is set to unix or openvms, the Tru64 UNIX
or OpenVMS operating system boots.
If the system is running the Windows NT operating system (the os_type
environment variable is set to nt), the SRM console loads and starts the
AlphaBIOS console.
See Section 2.19 for information on environment variables. See Chapter 2
for SRM console, and Chapter 3 for AlphaBIOS information.
To Next Page
Loading...
Need help?
General
