Compaq ALPHASERVER DS10 Reference Guide

Remote Management Console 4-31
4.14.16 set com1_mode
The set com1_mode command specifies the COM1 data flow
paths, so that data either passes through the RMC or bypasses it.
See Section 4.3 for descriptions of the RMC modes.
Syntax: set com1_mode value
where value can be:
snoop
soft_bypass
firm_bypass
Data partially bypasses the RMC, but the RMC taps into the
data lines and listens passively for the RMC escape sequence.
Data bypasses RMC, but the RMC switches automatically into
snoop mode if an alert condition or loss of carrier occurs.
Data bypasses the RMC. The RMC is effectively disabled.
Example:
"""WIXGSQCQSHI
'31C13()7233473*8C&=4%77*-61C&=4%77

Compaq ALPHASERVER DS10 Specifications

General

Brand	Compaq
Model	ALPHASERVER DS10
Category	Music Mixer
Language	English