Compaq ALPHASERVER DS10 - Page 211

Index-5
PCI options
slot numbers, 2-12
pci_parity environment variable,
SRM, 2-39, 2-47, 2-48
pk*0_fast environment variable, SRM,
2-39, 2-48
pk*0_host_id environment variable,
SRM, 2-39, 2-49
pk*0_soft_term environment variable,
SRM, 2-39, 2-49
power off command (RMC), 4-27
power on command (RMC), 4-28
Power-on/off, from RMC, 4-9
Power-up, specifying console action,
SRM, 2-40
prcache command, SRM, 2-4, 2-18
Primary operating system,
AlphaBIOS, 3-36
Q
quit command (RMC), 4-6, 4-28
R
Reading a file, 2-34
readme command, LFU, 1-41, 1-42
Remote console monitor. See RMC
Remote dial-in, 4-17
Remote power-on/off, 4-9
reset command (RMC), 4-16, 4-29
Reset, from RMC, 4-11
Reset, specifying console action,
SRM, 2-40
RMC
accessing, 4-5
auxiliary power supply, 4-1
clear alert command, 4-23
clear port command, 4-23
command conventions, 4-22
commands, 4-21
configuring call-out, 4-12
dial-out alerts, 4-14
disable alert command, 4-23
disable remote command, 4-24
enable alert command, 4-24
enable remote command, 4-25
entering, 4-6
escape sequence, 4-6
exiting, 4-6
halt in command, 4-26
hangup command, 4-13, 4-17, 4-27
help or ? commands, 4-27
power off command, 4-27
power on command, 4-28
quit command, 4-6, 4-28
remote halt, 4-11
remote power-on/off, 4-11
remote reset, 4-11
reset command, 4-29
resetting to factory defaults, 4-18
send alert command, 4-29
set alert command, 4-30
set dial command, 4-32
set escape command, 4-33
set init command, 4-34
set logout command, 4-35
set password command, 4-35
set user command, 4-36
status command, 4-7, 4-36
terminal setup, 4-3
troubleshooting, 4-19
RMC mode, 4-4
Running maintenance programs,
AlphaBIOS, 3-44
Running utility programs, 3-44
S
SCSI
enabling and disabling terminators,
SRM, 2-46
enabling Fast SCSI, SRM, 2-45
setting controller host bus node ID,
SRM, 2-46
SCSI configuration screen,
AlphaBIOS, 3-15
send alert command (RMC), 4-32